Seven engineering disciplines, delivered directly
We carry out mechanical and electrical engineering work ourselves. Each discipline below is handled by A.A. Samad Engineering staff on site, not coordinated through third parties.
HDPE piping and secondary containment
We supply and install high-density polyethylene piping for fuel lines, water distribution and chemical conveyance. Our teams perform butt fusion and electrofusion jointing on site, and we install secondary containment systems for forecourt and depot fuel infrastructure.
- Supply and installation of HDPE pipe and fittings
- Butt fusion and electrofusion jointing
- Secondary containment for underground fuel lines
- Leak detection system integration
- Pressure testing and commissioning
960x640 recommended
Mechanical engineering and pump systems
Pump selection, installation, pipework fabrication, tank fitting and repair, and scheduled preventive maintenance for industrial and commercial sites. We work on fuel submersible pumps, water pumps, booster systems and associated mechanical plant.
- Submersible and surface pump installation
- Pipework fabrication and fit-out
- Tank installation and structural repair
- Preventive maintenance programmes
- Mechanical plant inspection and overhaul
960x640 recommended
Electrical installation and panel building
Control panel fabrication and wiring, motor controls, instrumentation, earthing and lightning protection systems, and full power distribution installation for forecourts, factories, hotels and commercial premises.
- Panel building and switchgear installation
- Motor starter and VFD wiring
- Instrumentation and sensor installation
- Earthing and lightning protection systems
- Power distribution and cabling
- Emergency generator change-over panels
960x640 recommended
Water supply networks and automation
Complete water supply networks from borehole to storage to end distribution. We design and install level controls, automated dosing systems, water treatment lines and full pipework for water factories, hotels and industrial facilities.
- Borehole-to-storage pipework design and installation
- Water treatment and dosing systems
- Automated level control and float switches
- Water factory sanitary-grade piping
- Overhead and underground storage installation
- Distribution network commissioning
960x640 recommended
Tank calibration and documentation
Calibration of underground and above-ground tanks of all types and capacities. We issue calibration charts in the format required by regulators and operators, with full documentation for compliance, insurance and fuel-loss accounting purposes.
- Underground storage tank calibration
- Above-ground tank calibration
- Calibration charts in regulatory-accepted format
- Compliance and insurance documentation
- Wetstock reconciliation baseline
960x640 recommended
ATGs, dispensers and wetstock monitoring
Supply, installation and commissioning of automatic tank gauging systems, fuel dispensers, wetstock reconciliation software and remote monitoring solutions for fuel stations, depots and fleet operators.
- Automatic tank gauge installation and commissioning
- Fuel dispenser supply and installation
- Wetstock reconciliation system setup
- Remote tank monitoring and alerts
- Forecourt equipment maintenance contracts
960x640 recommended
Grid-tied and off-grid solar PV systems
Design, supply and installation of solar photovoltaic systems for commercial, industrial and residential facilities. We match system size to actual load, integrate correctly into existing switchgear, and commission against measured output.
- Site load assessment and system sizing
- Panel mounting, inverter wiring, battery banks
- Grid-tie interconnection and protection relays
- Earthing and lightning protection
- Commissioning, testing and operator handover
960x640 recommended
Tell us about your project
We work on any scope from single equipment replacement to full system installation. Call us or send a brief and we will respond with what we can do.
Request a Quote