Electrical and Electronics Engineering
Control panel fabrication, motor wiring, instrumentation, earthing and power distribution for forecourts, industrial facilities, hotels and commercial premises across Nigeria.
Electrical systems built to work reliably in Nigerian operating conditions
Nigeria's power grid is unreliable. Most industrial and commercial sites depend on generators, inverters or hybrid power. The electrical installation on these sites has to handle frequent switching between sources, voltage variations and the mechanical stress that comes from that environment.
We build control panels and carry out wiring that accounts for these conditions. We do not cut corners on earthing, protection devices or cable sizing — failures in those areas create safety risks and expensive damage.
Forecourt electrical work is a significant part of our practice. ATG wiring, pump motor controls, dispenser power, lighting and earthing on fuel stations require specific knowledge of the environment and hazardous area classification requirements.
800x600 recommended
Scope of work
- Control panel fabrication and wiring
- Motor starter and VFD panels
- Generator change-over and ATS panels
- Power distribution boards and sub-boards
- Instrumentation and sensor wiring
- ATG and dispenser electrical connection
- Earthing system design and installation
- Lightning protection systems
- Cable tray, conduit and armoured cable installation
- Electrical inspection, testing and certification documentation
From assessment to energisation
Load assessment and design
We assess the electrical loads, existing supply capacity and protection requirements before specifying panel size, cable ratings and protective devices. For forecourts, we identify hazardous zones that affect cable and equipment selection.
Panel fabrication
Control panels are built in our workshop using correct-rated components. We do not reuse undersized breakers or shortcuts that pass on risk to the site.
Site installation
Panels, cable runs, earthing and instrumentation wiring are installed on site by our electricians. We coordinate with mechanical teams where systems are interdependent.
Testing and commissioning
We test insulation resistance, continuity and earth fault loop impedance before energisation. We commission the system under load and hand over with test records and panel schedules.
Industries that use this service
Need electrical installation or panel work?
Tell us the scope and site. We will assess and quote accurately.
Request a Quote